Thecore of the Drinkpure water filtration system is a polymer membrane (W02012/ 097967), which was developed by Swiss company: Novamem Ltd. The outdoor round filter disk (12 cm in diameter) exhibits around 6. 3 bilLions of pores. The membrane is produced and controlled by NovamemLtd. See how allparts fit together to build a Drinkpure water filter. Our membrane production process generates up to 4 times less waste water than other comparable processes. 

High throughput

Our patented technology enables us to produce membranes with a very high amount of pores at the desired pore size. This generates unrivalled flow rates. The filter is able to remove more than 99. 9999 % of bacteria and more than 99 % of viruses. it also removes odors Like the smell of chlorine.

Simple use

Simply screw the Drinkpure water filtration system on your PET bottle (works with almost any bottle!). Then you can enjoy filtered water by gently squeezing the bottle (use only one hand). Whenever and wherever!

 Self-disinfecting

The Drinkpure water filtration system comes along with a self-disinfecting Layer to prevent welL-known filter fouling during times of no use.

•  Outdoor Membrane protection

If the applied pressure is too high for the membrane (e. g. squeezing with both hands), a by-pass mechanism wilL Lead the unfiltered water around the membrane, protecting it from rupture. 

HOW TO USE YOUR OUTDOORFILTRATION SYSTEM

•          Fill your bottle

FILL water in your bottle according to our  •safety instructions. •
          screw

•The Drinkpure water filtration system can basically be screwed on almost every  international standard PET bottle. You may want to check the fitting with your bottle type prior to filling. •  

         Squeze, drink, enjoy!

•By gently squeezing the bottle with one hand, filtered water flows out. Discard the first glass. Your filter is now ready f or use. Simultaneous squeezing and sucking allows an even better drinking experience.  

Enjoy filtered water, wherever you go! 

MAINTENANCE OF OUTDOOR DRINKPURE 

You can extend the life time of your filter by regular maintenance.

•  Backwashing

By flushing water in the opposite direction, dirt can be removed from the membrane pores. Backwash your filter when you feel that the water flow rate decreases. To do so, use the included syringe. Do not apply sudden or high pressure. Additional syringes can be bought on our webpage www. drinkpure-waterfilter. com or www.drinkpure.com.cn . The Drinkpure water filtration system is not dishwasher-safe.

•  Drying and storage

Try to store the Drinkpure water filtration system under dry conditions. The Drinkpure water filtration system must not be dried by any heat source (e. g. Baking oven). Please back flush your filter prior to a Longer storage. You can gently put a paper towel into the thread to further dry the filter. The self-disinfecting Layer prevents well-known filter fouling during the storage period.

•  Valve maintenance

If the Drinkpure is used for the first time or after storing the Drinkpure for a long time, the ventilation valve can stick together. To reopen this valve, blowing a few breaths of air through the valve can do the trick. Also, a cotton swab can be used to slightly push the valve open again. Be careful to avoid damage to the membrane inside.